CNC Set Up Operator -Night shift


City: Brampton, Ontario, Canada
Title: CNC Set Up Operator -Night shift
Category: Other Specialties
EmploymentType: Temp-to-Hire
Description:

Staffmax is looking for CNC Set up Operator. It is a Full time Permanent job.

Location: Brampton.

Shift - Day/Night shift

Pay rate- $22 + $1 night shift premium.

JOB DESCRIPTION

Directly responsible to Press Team Leader. Functionally responsible for operating Press, Process Equipment and Handling Equipment. Ensure that a safe working environment is maintained at all times. This will be done by following Company policies and procedures. We believe that every Employee is responsible to act safely and to model good safety practices.

DUTIES AND RESPONSIBILITIES

The duties and responsibilities of the Extrusion Press Operator are detailed below, but not limited to the following:

Operator #1

Die management; Ensure all necessary tooling is available at the beginning and throughout shift.
Load dies into press; Maintain die change times per press as specified in Production Roles.
Check finish and dimensions on extrusions at the required frequency.
Ensure press signoffs after samples are checked.
Ensure proper billets/logs are in the ovens and monitor the supply to keep press going.
Press samples must be properly labelled and kept together for traceability.
Complete press Ascoma scans as required.
Operator #2:

Operation of Extrusion Press at the best possible speed while maintaining a good quality extrusion, start each order off by running no less than the average speed of each die.
Keep track of equipment performance and ensure press is well tuned, and temperatures are being properly managed from billet oven to exit temperature.
Use the first billet whenever possible to cut samples since that extrusion is likely shorter than subsequent billets and cutting samples from subsequent billets may result in losing one cut length.
Mark cavity numbers on the samples and the corresponding extrusions on the cooling table so the saw operator can cut and save these after stretching.
Check the run out at the beginning of each order and report to Team Leader if billet length scheduled is inappropriate and have it changed if it will improve yield.
Ensure proper lead-out of extrusion into puller jaws,
Run clean-out dummy block at least once every shift and perform the required PM checks
Have sufficient walks between extrusions transferred onto cooling table,
Ensure all billets and alloy used are accounted for in Epics,
Read and follow all notes in Epics applicable to press section.
Operator #1 and #2

Help with maintaining press and related process equipment in the event of breakdown,
Look for opportunities to improve press output
Comply with all quality related policies, procedures, and system requirement.
Education/Experience

Must have proven skills in operation of any press operation with the ability to learn this trade.
Ability to read drawings and measurement equipment.
Min. grade 10 with written and oral skills or technical training that is equivalent. Grade 12 would be an asset.
Technical Skills/Competence

1-2 years of experience in a production environment.
Ability to lift up to 50lbs independently, and ability to lift up to 100 lbs in collaboration with team member.
We thank everyone who applies; only candidates being considered will be contacted.

Company:
Staffmax Staffing & Recruiting